Typ produktu |
Česká technická norma (ČSN) |
Oznaèení zákl. dokumentu |
ČSN EN ISO 5167-2 |
Zmìna/oprava/svazek |
|
Tøídicí znak |
257710 |
Katalogové èíslo |
515775 |
Název dokumentu |
Měření průtoku tekutin pomocí snímačů diferenčního tlaku vložených do zcela zaplněného potrubí kruhového průřezu - Část 2: Clony |
Anglický název |
Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full - Part 2: Orifice plates |
Datum vydání |
01.01.2023 |
Datum ukonèení platnosti |
01.01.2024 |
Datum úèinnosti |
01.02.2023 |
Vìstník vydání (mìs/rok) |
1/23 |
Vìstník zrušení |
|
Zpùsob vydání |
ve věstníku |
Zpùsob pøevzetí originálu |
vyhlášením |
Bude pøeložena |
Ne |
Použité jazyky |
|
ICS kódy |
17.120.10 - Průtok v uzavřených profilech
|
Subsektor |
|
Deskriptory |
|
Klíèová slova |
|
Harmonizace/Urèení |
Informace o harmonizovaných a urèených normách jsou zveøejnìny v Databázi harmonizovaných norem
|
Zapracované dokumenty |
Oznaèení | Rok vydání |
EN ISO 5167-2 | 2022 |
ISO 5167-2 | 2022 |
|
Zmìny |
|
Opravy |
|
Nahrazuje dokumenty |
Katalogové èíslo | Oznaèení | Rok vydání |
68917 | ČSN EN ISO 5167-2 | 2003 |
|
Byla nahrazena dokumenty |
Katalogové èíslo | Oznaèení | Rok vydání |
518261 | ČSN EN ISO 5167-2 | 2023 |
|
Anotace |
ČSN EN ISO 5167-2 This document specifies the geometry and method of use (installation and operating conditions) of orifice plates when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit. This document also provides background information for calculating the flow rate and is applicable in conjunction with the requirements given in ISO 5167 1. This document is applicable to primary devices having an orifice plate used with flange pressure tappings, or with corner pressure tappings, or with D and D/2 pressure tappings. Other pressure tappings such as "vena contracta" and pipe tappings are not covered by this document. This document is applicable only to a flow which remains subsonic throughout the measuring section and where the fluid can be considered as single phase. It is not applicable to the measurement of pulsating flow[1]. It does not cover the use of orifice plates in pipe sizes less than 50 mm or more than 1 000 mm, or where the pipe Reynolds numbers are below 5 000. |