Typ produktu |
Česká technická norma (ČSN) |
Oznaèení zákl. dokumentu |
ČSN EN ISO 13259 |
Zmìna/oprava/svazek |
|
Tøídicí znak |
646459 |
Katalogové èíslo |
511374 |
Název dokumentu |
Potrubní systémy z termoplastů pro beztlakové aplikace uložené v zemi - Stanovení těsnosti spojů s elastomerním těsnicím kroužkem |
Anglický název |
Thermoplastics piping systems for underground nonpressure applications - Test method for leaktightness of elastomeric sealing ring type joints |
Datum vydání |
01.02.2021 |
Datum ukonèení platnosti |
|
Datum úèinnosti |
01.03.2021 |
Vìstník vydání (mìs/rok) |
2/21 |
Vìstník zrušení |
|
Zpùsob vydání |
ve věstníku |
Zpùsob pøevzetí originálu |
vyhlášením |
Bude pøeložena |
Ne |
Použité jazyky |
|
ICS kódy |
23.040.20 - Trubky z plastů 91.140.80 - Kanalizační systémy
|
Subsektor |
|
Deskriptory |
|
Klíèová slova |
|
Harmonizace/Urèení |
Informace o harmonizovaných a urèených normách jsou zveøejnìny v Databázi harmonizovaných norem
|
Zapracované dokumenty |
Oznaèení | Rok vydání |
EN ISO 13259 | 2020 |
ISO 13259 | 2020 |
|
Zmìny |
|
Opravy |
|
Nahrazuje dokumenty |
Katalogové èíslo | Oznaèení | Rok vydání |
505744 | ČSN EN ISO 13259 | 2018 |
|
Byla nahrazena dokumenty |
|
Anotace |
ČSN EN ISO 13259 This International Standard specifies three basic test pressures for determining the leaktightness of elastomeric sealing ring type joints for buried thermoplastics non-pressure piping systems. Unless otherwise specified in the referring standard, the methods use the following pressures: p1: internal negative air pressure (partial vacuum); p2: low internal hydrostatic pressure; p3: higher internal hydrostatic pressure. It also describes the following four conditions under which the test can be executed: a) A: without any additional diametric or angular deflection; b) B: with diametric deflection; c) C: with angular deflection; d) D: with simultaneous angular and diametric deflection. These conditions can be applied individually or in combination. The applicable selection of the method(s) and the condition(s) should be specified in the referring standard. |