Detailní informace o produktu

Typ produktu Česká technická norma (ČSN)
Oznaèení zákl. dokumentu ČSN EN 17176-1
Zmìna/oprava/svazek
Tøídicí znak 646446
Katalogové èíslo 507891
Název dokumentu Plastové potrubní systémy pro rozvody vody a tlakové kanalizační přípojky, stokové sítě a odvody dešťové vody uložené v zemi i nad zemí - Molekulárně orientovaný neměkčený polyvinylchlorid (PVC-O) – Část 1: Obecně
Anglický název Plastics piping systems for water supply and for buried and above ground drainage, sewerage and irrigation under pressure - Oriented unplasticized poly(vinyl chloride) (PVC-O) - Part 1: General
Datum vydání 01.10.2019
Datum ukonèení platnosti
Datum úèinnosti 01.11.2019
Vìstník vydání (mìs/rok) 10/19
Vìstník zrušení
Zpùsob vydání ve věstníku
Zpùsob pøevzetí originálu vyhlášením
Bude pøeložena Ne
Použité jazyky
ICS kódy 23.040.20 - Trubky z plastů
23.040.45 - Fitinky z plastů
Subsektor
Deskriptory
Klíèová slova
Harmonizace/Urèení Informace o harmonizovaných a urèených normách jsou zveøejnìny v Databázi harmonizovaných norem
Zapracované dokumenty
OznaèeníRok vydání
EN 17176-12019
Zmìny
Opravy
Nahrazuje dokumenty
Byla nahrazena dokumenty
Anotace

ČSN EN 17176-1 This part of EN 17176 specifies the material characteristics of oriented unplasticized poly(vinyl chloride) (PVC-O) solid wall piping systems intended for water supply and for buried drainage, sewerage and irrigation under pressure or above-ground where protected from direct sunlight. In conjunction with EN 17176-2, CEN/TS 17176-3 and EN ISO 1452-3, it is applicable to PVC-O pipes, PVC-O fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for the following: a) water mains and services lines; b) conveyance of water for both outside and inside buildings; c) drainage, sewerage and treated waste water under pressure; d) irrigation under pressure. Joints constructed of other materials will meet their own standards in addition to the fitness of purpose requirements specified in EN 17176-5. It is applicable to piping systems intended for the supply of water with a maximum allowable operating pressure (PFA) up to and including 25 bar1). The piping system according to this document is intended for the conveyance of cold water up to and including 45 °C and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations. For temperatures between 25 °C and 45 °C, EN 17176-2:2018, Figure C.1 applies. It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.