Typ produktu |
Česká technická norma (ČSN) |
Oznaèení zákl. dokumentu |
ČSN EN ISO 6145-7 |
Zmìna/oprava/svazek |
|
Tøídicí znak |
385615 |
Katalogové èíslo |
507397 |
Název dokumentu |
Analýza plynů - Příprava kalibračních plynných směsí s použitím dynamických metod - Část 7: Tepelné regulátory hmotnostního průtoku |
Anglický název |
Gas analysis - Preparation of calibration gas mixtures using dynamic methods - Part 7: Thermal mass-flow controllers |
Datum vydání |
01.07.2019 |
Datum ukonèení platnosti |
|
Datum úèinnosti |
01.08.2019 |
Vìstník vydání (mìs/rok) |
7/19 |
Vìstník zrušení |
|
Zpùsob vydání |
ve věstníku |
Zpùsob pøevzetí originálu |
vyhlášením |
Bude pøeložena |
Ne |
Použité jazyky |
|
ICS kódy |
71.040.40 - Chemická analýza
|
Subsektor |
|
Deskriptory |
|
Klíèová slova |
|
Harmonizace/Urèení |
Informace o harmonizovaných a urèených normách jsou zveøejnìny v Databázi harmonizovaných norem
|
Zapracované dokumenty |
Oznaèení | Rok vydání |
EN ISO 6145-7 | 2018 |
ISO 6145-7 | 2018 |
|
Zmìny |
|
Opravy |
|
Nahrazuje dokumenty |
Katalogové èíslo | Oznaèení | Rok vydání |
87919 | ČSN EN ISO 6145-7 | 2011 |
|
Byla nahrazena dokumenty |
|
Anotace |
ČSN EN ISO 6145-7 ISO 6145 is a series of documents dealing with various dynamic methods used for the preparation of calibration gas mixtures. This document specifies a method for continuous preparation of calibration gas mixtures, from nominally pure gases or gas mixtures by use of thermal mass-flow controllers. The method is applicable to preparation of mixtures of non-reacting species, i.e. those which do not react with any material of construction of the flow path in the thermal mass-flow controller or the ancillary equipment. If this method is employed for preparation of calibration gas mixtures the optimum performance is as follows: the relative expanded measurement uncertainty U, obtained by multiplying the standard uncertainty by a coverage factor k = 2, is not greater than 2 %. If pre-mixed gases are used instead of pure gases, mole fractions below 10-6 can be obtained. The measurement of mass flow is not absolute and the flow controller requires independent calibration. The merits of the method are that a large quantity of the calibration gas mixture can be prepared on a continuous basis and that multi-component mixtures can be prepared as readily as binary mixtures if the appropriate number of thermal mass-flow controllers is utilized. |